Brochure Crazydrill Cool Titanium
FOR EACH TITANIUM IT’S DRILL!
Drilling titanium is highly demanding. One of the reasons is the combination of its high elasticity and tensile strength. Because of its high toughness, chip breaking is difficult to realize, and due to the low thermal conductivity of titanium, heat diffuses directly into the tool. In addition, titanium tends to form built-up edges. All of this leads to higher wear, poor surface quality, and insufficient process reliability.
In addition, not all titanium is the same. Depending on the titanium, pure or alloyed, the machinability is very different. Mikron
Tool has therefore developed two new products:
- CrazyDrill Cool Titanium PTC for pure titanium
- CrazyDrill Cool Titanium ATC for titanium alloys
These drills, which are perfectly matched to the respective titanium grades, achieve maximum drilling performance and high process reliability. It is now possible to drill titanium alloys up to 10xd in a single step without multiple pecking for chip removal.
